cdx f5700�705x djvu

CDX-F5700/F5705X

US Model Canadian Model

CDX-F5705X

SERVICE MANUAŁ

Ver 1.0 2004.02

AEP Model UK Model E Model

CDX-F5700

Photo: CDX-F5700

Model Name Using Similar Mechanism	CDX-F5700/F5700X/FW570
CD Drive Mechanism Type	MG-6 tt MA-t 86//Q
Optical Pick-up Name	KSStOOOE

* The tuner and CD sections have no adjustments.

AUDID PDWER SPECIFICATIDNS (US MD DEL)

POWER OUTPUT AND TOTAL HARMON1C DISTORTION 23.2 watts perchannel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no morę than 5% total harmonie distoition.

SPECIFICATIONS

120 dB

10-20,000 Hz Below ineasurable limit

US, Canadian Model:

87.5-    107.9 MHz AEP, UK Model:

87.5-    108.0 MHz E Model:

FM tuning interval: 50 kHz/200 kHz

E Model:

AM tuning interval:

9 kHz/10 kHz switchable 531 - 1,602 kHz (at 9 kHz step) 530 - 1,710 kHz (at 10 kHz step) Extemal antenna connector

CD player section

Signal-to-noise ratio Frequency response Wow and flutter

Tuner section FM

Tuning rangę

switchable

87.5    - 108 MHz (at 50 kHz step)

87.5    - 107.9 MHz (at 200 kHz step)

Antenna terminal    Extemal anten na connector

Intennediate frequency    10.7 MHz/450 kHz

Usable sensitivity    9 dBf

Selectivity    75 dB at 400 kHz

Signal-to-noise ratio    67 dB (stereo),

69 dB (mono)

Harmonie distortion at 1 kHz

0.5% (stereo),

0.3% (mono)

Separation    35 dB at 1 kHz

Frequency response    30 - 15,000 Hz

AM (US, Canadian Model)

Tuning rangę    US, Canadian Model:

530- 1,710 kHz

Antenna terminal

Intermediate frequency	10.7 MHz/450 kHz
Sensitivity	30 pV
MW/LW (AEP, UK Model)
Tuning rangę	MW: 531 - 1,602 kHz LW: 153 - 279 kHz
Aerial terminal	External aerial connector
Intermediate frequency	10.7 MHz/450 kHz
Sensitivity	MW: 30 pV LW: 40 pV
Power amplifier section
Outputs	Speaker outputs (surę seal connectors)
Speaker impedance	4 — 8 ohms
Maximum power output US, Canadian, E Model:
	52 W x 4 (at 4 ohms) AEP, UK Model: 50 W x 4 (at 4 ohms)
General Outputs	Audio outputs terminal (ftont/rear) Subwoofer output terminal (mono) Power antenna relay control terminal Power amplifier control terminal

— Continued on next page —

FM/AM COMPACT DISC PLAYER

US, Canadian, E Model

FM/MW/LW COMPACT DISC PLAYER

AEP, UK Model

9-877-606-01

2004B04-t © 2004. 02

Sony Corporation

e Vehicie Company

Publishcd by Sony Engineering Corporation

SONY

•    R-ch is omitted due to same as L-ch.

•    Siganal Path

SOUNDCONTROL, ELECTRONIC V0LUME 10351

SYSTEM CONTROL    LCD DRIVER

IC600 (3/3)    IC901

o-5. CIRCUIT BOARDS LOCATION

SERVO board

3-6. NOTĘ FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS

THIS NOTĘ IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.

(In addltion to thls, the necessary notę Is printed In each błock.)

For schematic dlagrams.

Notę:

•    Ali capacitors are in pF unless otherwise noted. pF: ppF 50 WV or less are not indicated except for electrolytics and tantalums.

•    Ali resistors are in fi and 'A W or less unless otherwise specified.

•    a : intern al component.

•    I I : panel designation.

For printed wiring boards.

Notę:

•    o- : parts extracted from the component side.

•    - : parts extracted from the conductor side.

•    O : Through hole.

•    | : Pattern from the side which enables seeing. (The other layers’ pattems are not indicated.)

Notę:

The components identi-fied by mark A or dotted linę with mark A are criti-cal for safety.

Replace only with part number specified.

Notę:

Les composants identifies par une marque A sont critiques pour la securite.

Ne les remplacer que par une piece portant le numśro specifie.

Caution:

Pattern face side: Parts on the pattern face side seen from the (Side B)    pattern face are indicated.

Parts face side: Parts on the parts face side seen from the (Side A)    parts face are indicated.

•    : B+ Linę.

•    — :B~Line.

*    I i : adjustment for repair.

*    Voltages and waveforms are dc with respect to ground under no-signal (detuned) conditions.

*    CD mechanism section (1/2), (2/2) no mark : CD PLAY

•    Main (1/2), (2/2) and Display sections no mark : FM

(    )    :AM

<    >    : CD PLAY

—These are omitted

- These are omitted

*    : Impossible to measure

Voltages are taken with a VOM (Input impedance 10 Mfi). Voltage variations may be noted due to normal produc-tion tolerances.

Waveforms are taken with a oscilloscope.

Voltage variations may be noted due to normal produc-tion tolerances.

Circled numbers ref er to waveforms.

ECB

— These are omitted

Abbreviation

CND : Canadian model.

Si gnał path. e£>    : CD PLAY

O : FM

: AM/MW/LW :BUS AUDIO Abbreviation CND : Canadian model.

3-7. WAVEFORMS

Approx.

*150m.Vp-p

kmmmm.

— Servo Board -

(MODĘ: CD PLAY)

Approx. 100mVp-p

IC3 © (TEI)

©

Approx. 100mVp-p

IC3 © (FEI)

©

mmm

IC3 @ (A), © (C)

©

— Main Board —

©
WALI	2.2Vp-p
27.648MHz IC600 © (OSCOUT)
©
WAL	1.8Vp-p
32.768kHz IC600 ® (XOUT)
©
W/\L	2.8Vp-p
8.664MHz IC50 © (XTO)

mmmm.

mmsm

IC3 © (B), © (D)

,Approx.

M50mVp-p

©

mmmm,

rnrnsm

IC3 ® (RFACO)

Approx.

0.8Vp-p

©z

T

2Vp-p

16.9344MHz

IC3 © (XTAO)

©/

T

1Vp-p

18.43MHz

IC4 ® (X1)

3-9. SCHEMATIC DIAGRAM — CD MECHANISM SECTION (1/2) — • Refer to page 24 for Waveforms.

1    |    2    |    3    |    4    |    5    | E |    7    | B |    9    |    10    |    11    |    12    |    13    |    1*    |_1£

>

3-14. PRINTEJ WIRING BOARD — SUB SECTION — • Refer to page 23 for Circuit Boards Location. S_: Usei unleaded solder.

3-15. SCHEMATIC DIAGRAM — SUB SECTION —

3-17- SCHEMATIC DIAGRAM — DISPLAY SECTION -

J_§_L

_§_L

J3_L

J_15_L

| 10 | 11 | 12

1A

IG

33 33