66

66



CYLINDER HEAD

Inspection


Disassembly (Cont'd)

6. Remove va!ve component parts.


4.    Remove rocker shaft with rocker arms.

5.    Remove camshaft.

CYLINDER HEAD DISTORTION

Measuring points

If beyond the specified limit, resurface it. Resurfacing limit:

The rpsurfacing limit of cylinder head is aeter-mined by the cylinder błock resurfacing in an engine.

Amount of cylinder head resurfacing is "A". Amount of cylinder błock resurfacing is "B". The maximum limit is as follows:

A + B = 0.2 mm (0.008 in)

SEM991

VALVE GUIDE CLEARANCE

7. Remove vaive on seais.


KV10107900 ( - )


• Valve guiae ciearance snoulo be measurec in parallel with rocker arm. (Generally, a iarge amount of wear occurs in this direction.)

28 mm (1.10 in)


Stern to guide ciearance: Maximum limit 0.10 mm (0.0039 in) Max. allowabie deflectcon (Dial indicator reading) 0.2 mm (0.008 in)

SEM644



Wyszukiwarka

Podobne podstrony:
CYLINDER HEAD 4Inspection (Cont d) Replacement Replace valve or valve guide. 1. Heat cylinder head t
CYLINDER HEAD .AssemblyInspection (Cont’d) KV10109500 (
CYLINDER HEAD InstallationAssembly (Cont d) --:l 6. Install rocker shaft with rocker arms. Oil pump
CYLINDER HEAD-Installation (Cont d)- 2.    Install cylinder head with new gasket. a.
Suzuki RM250I 44 CYLINDER. CYLINDER HEAD AND PISTON •    Remove the cylinder nuts. NO
FRONT AXLE — Drive Shaft InspectionDisassembly (Cont d) • Remove snap ring, and withdraw inner race.
89 TransAlp Manual Cylinder Head Valve 9 CYLINDER HEAD/VALVE Remove and inspect each valve.CAUTION
89 TransAlp Manual Cylinder Head Valve 9 9 CYLINDER HEAD/VALVEDISASSEMBLY/INSPECTION Remove the valv
Suzuki RM125y 6-6 CYLINDER, PISTON AND EXHAU$T VALVECYLINDER HEAD INSPECTION •    Rem
MANUAŁ STEERING GEAR AND LINKAGE — R22TDiassembly (Cont d)__Inspection_ RACK 1. Remove tie-rod inner
ENGINE OVERHAUL— Inspection (Cont d)_ CRANKSHAFT RUNOUT Check crankshaft runout. CYLINDER BORĘ Using
ENGINE OVERHAUL_Inspection (Cont d)— PISTON TO CYLINDER WALL CLEARANCE 1. Measure piston
89 TransAlp Manual Cylinder Head Valve 9 Valve guide reamer JCYLINDER HEAD/VALVE Measure and record
89 TransAlp Manual Cylinder Head Valve 9 CYLINDER HEAD/VALVE Use a 60 degree cutter to remove the b
89 TransAlp Manual Cylinder Head Valve 9 3 CYLINDER HEAD/VALVECYLINDER HEAD COVER REMOVAL Drain the
89 TransAlp Manual Cylinder Head Valve 9 4 CYLINDER HEAD/VALVECAM CHAIN INSPECTION Measure the heigh
89 TransAlp Manual Cylinder Head Valve 9 8 CYLINDER HEAD/VALVECYLINDER HEAD REMOVAL Remove the engin

więcej podobnych podstron