89 TransAlp Manual Hydraulic Brake 8

89 TransAlp Manual Hydraulic Brake 8



HYDRAULIC BRAKE

INSPECTION

Measure the master cylinder I.D.

SERN/ICE LIMIT: 12.76 mm (0.502 in)

Check the master cylinder for scores, scratches or nicks.

Measure the master piston O.D. at the position as shown. SERVICE LIMIT: 12.65 mm (0.498 in)

Check the primary and secondary cups for damage before as-sembly.

ASSEMBLY

CAUTION

Handle the master cylinder piston, cylinder and spring as a set.

Coat ail parts with clean brake fluid before assembly.

Install the spring and piston.

CAUTION

•    When installing the cups, do not allow the lips to turn inside out.

•    Install the spring with its wide end toward inside.

Install the snap ring.

CAUTION

Be certain that the snap ring is seated firrnly in the groove. TOOL:

Snap ring pliers    07914—3230001






Wyszukiwarka

Podobne podstrony:
89 TransAlp Manual Hydraulic Brake 1 15. HYDRAULIC BRAKE SERN/ICE INFORMATION 15-1 BRAKE
89 TransAlp Manual Hydraulic Brake HYDRAULIC BRAKE If necessary, apply compressed air to the calip
89 TransAlp Manual Hydraulic Brake HYDRAULIC BRAKEr> #!> Install the boot to the bracket. Ap
89 TransAlp Manual Hydraulic Brake 2 HYDRAULIC BRAKETROUBLESHOOTING Brake lever soft or spongy • &n
89 TransAlp Manual Hydraulic Brake 3 HYDRAULIC BRAKE HYDRAULIC BRAKEBRAKE FLUID REPLACEMENT/AIR BLE
89 TransAlp Manual Hydraulic Brake 4 HYDRAULIC BRAKE Bleed air from the bleed valve on the caliper
89 TransAlp Manual Hydraulic Brake 5 HYDRAULIC BRAKE Pry one old pad against the caliper with a scr
89 TransAlp Manual Hydraulic Brake 6 HYDRAULIC BRAKE <1) PAD PIN RETAINER BOLT^yy^, ip^piVOT Pla
89 TransAlp Manual Hydraulic Brake 7 HYDRAULIC BRAKEMASTER CYLINDERREMOVAL Drain brake fluid from t
89 TransAlp Manual Hydraulic Brake 9 HYDRAULIC BRAKE * t fINSTALLATION Set the master cylinder onto
89 TransAlp Manual Crankshaft Transmission 6 CRANKSHAFT/TRANSMISSION Remove the bearing caps and co
89 TransAlp Manual Cooling System 5 4 COOLING SYSTEMINSPECTION Inspect the thermostat visually for d
89 TransAlp Manual Cooling System 5 6 COOLING SYSTEMRADIATORREMOVAL Drain the coolant (page 5-3). Re
89 TransAlp Manual Cooling System 5 7 COOLING SYSTEM Remove the nut and fan. Remove the fan motor mo
89 TransAlp Manual Crankshaft Transmission CRANKSHAFT/TRANSMISSION Install the M5 bushing onto the
89 TransAlp Manual Electric Starter 2 ELECTRIC STARTERTROUBLESHOOTING NOTĘ •    The
89 TransAlp Manual Electric Starter 4 ELECTRIC STARTER Inspect the commutator bars for discoloratio
89 TransAlp Manual Electric Starter 6 ELECTRIC STARTER Install the shims in the same location and n
89 TransAlp Manual Fuel System 4 FUELSYSTEM Inspect the float valve seat and filter for grooves, ni

więcej podobnych podstron